The Remote Control System; Transmitter - XciteRC one10MT Mode D'emploi

The remote control system

Here you get an overview of the remote control system of your One10 MT and
its various features and settings. Before the first flight, you should have read
EN
and understood all these functions and settings.
• Make sure that the transmitter is turned off - ON / OFF switch in position O.
• Now open the battery compartment cover on the bottom of the transmit-
ter and insert two AA batteries (or rechargeable batteries) into the battery
compartment of the transmitter. Pay attention to the correct polarity!
• Close the battery compartment cover.
• NOTE: pay attention to the red LED during operation. If the LED fla-
shes, stop driving as soon as possible and replace transmitter batteries (or
recharge the batteries) – crash hazard!

Transmitter

A: Steering wheel: direction right or left
B: Throttle trigger: controls the speed and direction of the model
C: Battery compartment
1. Control trim: adjusts the straight ahead driving
2. Servoreverse steering
3. On / Off Switch: Turns the power of the transmitter ON / OFF
4. Throttle trim: adjust the neutral position of the controller (always in the middle position!)
5. POWER/BIND-LED: indicates the battery voltage and a „bound receiver"
NOTE: the adjuster for the throttle trim TH.TRIM and the servo reverse switches for steering ST.REV
must not be adjusted. So check the correct position before every ride: throttle trim to the center position
(mark on the adjuster points up), steering reverse: switch in position N.
18
A
B
1
2
3
C
The remote control system
4
5
One10 MT