Handling Precautions For Batteries Or Rechargeable Batteries; The Remote Control System - XciteRC X-Dive micro Série Mode D'emploi

Warnings and safety notes · RC System

Handling precautions for batteries or rechargeable batteries

• Keep batteries away from children! Never let batteries unattended, as they can be swallowed by children
or pets!
• Use only the recommended or equivalent type of batteries / rechargeable batteries.
• WARNING: Do not expose batteries / rechargeable batteries to heat or throw into fire – fire or
explosion hazard!
• WARNING: Insert batteries / rechargeable batteries with the correct polarity, no short-circuiting –
fire or explosion hazard!
• If possible, always replace all batteries at the same time, never use new and used batteries and batteries
with different charge levels simultaneously.
• WARNING: Do not use defective or damaged batteries or rechargeable batteries – fire hazard!
Risk of chemical burns on contact with skin, use protective gloves!
• WARNING: Do not attempt to recharge non-rechargeable batteries in a charger – fire or explosion
hazard!
• Remove the rechargeable batteries from the device before charging.
• WARNING: Charging may take place only with a suitable charger for the type of battery on a fire-
proof surface and under constant adult supervision – fire hazard!
• Immediately remove used batteries from the devices.
• NOTE: NiMH batteries must be checked at least every 3 months and, if necessary, recharged, other-
wise because of the typic self-discharge they may get deep discharged and damaged! Therefore, better
use so-called RTU batteries with a very low self-discharge.
• NOTE: note the specified storage voltage for lithium batteries. Is a completely full or empty lithium
battery time stored for a longer time, it can be damaged.
The XciteRC Modellbau GmbH & Co. KG cannot monitor the proper use of the battery or batteries you use,
therefore, the warranty is excluded due to incorrect charging or discharging.

The remote control system

Here you get an overview of the remote control system of your X-Dive micro U-Boot and its various features
and settings. Before the first ride, you should absolutely have read and understood all these functions and
settings.
• Open the battery compartment cover on the bottom of the transmitter (1) with a suitable Phillips screwdri-
ver and insert four AAA batteries (or rechargeable batteries) into the battery compartment of the transmit-
ter (2). Pay attention to the correct polarity!
• Close the battery compartment cover and tight the srews. Pay attention to the seal to get the transmitter
waterproof.
Cover
• When pushing a transmitter button the transmitter LED lights up.
X-Dive micro U-Boot
4x AAA size alkaline battery
(not included)
Antenna
Screwdriver
(not included)
EN
15