The Remote Control System - XciteRC Flybar 190 4K 2.4 GHz blue Mode D'emploi

The remote control system

Here you get an overview of the remote control system of your XciteRC Flybar 190 and its various features
and settings. Before the first flight, you should absolutely have read and understood all these functions and
EN
settings.
• Do make sure that the transmitter is turned off - ON / OFF switch in the lower position.
• Now open the battery compartment cover on the bottom of the transmitter (1) and insert six AA batteries
(or rechargeable batteries) into the battery compartment of the transmitter (2). Pay attention to the correct
polarity!
1
Slide the battery cover in
arrow direction to open
• Close the battery compartment cover, then turn on transmitter – push ON / OFF switch upwards.
• When the red POWER LED is flashing, move the left throttle lever to the top position, then back to the
bottom. The POWER LED will light red and a short beep sounds. This safety circuit prevents the rotor may
start after turning on the helicopter.
• The POWER LED must lit red. Attention: if the POWER LED flashes or does not light at all, supported
by a warning tone, the model may not started – crash hazard! Change transmitter batteries immediately.
• WARNING: check the POWER LED also during operation. If the POWER LED starts to blink, sup-
ported by a beep, stop operation, switch the model off and replace the transmitter batteries – crash
hazard!
ATTENTION: The maximum range of the remote control system is about 50 meters, do not fly
•
farther away under any circumstances! If the XciteRC Flybar 190 gets out of range, the fail-safe function
is activated and turns off the motor.
22
2
Push
Use 6x AA size batteries, installed
based on polarity indicated case. No
mix batteries of different chemistry/spec.
The remote control system
Transmitter
Battery cover
XciteRC Flybar 190