Getting Started; Operation - XciteRC Flybar 190 4K 2.4 GHz blue Mode D'emploi

throttle that the helicopter is hoovering about 50 cm above
the ground.
NOTE: do not stay nearer to the ground, otherwise
EN
the helicopter is difficult to control because of its own air
turbulence. But also not higher, to avoid heavy damage by
a crash. Move the right lever carefully in all directions to get
a feeling for the reaction of the helicopter.
3. Yaw: this means to turn the helicopter around its own axis.
Specify just so much throttle that the helicopter is hovering
about 50 cm above the ground.
NOTE: do not stay nearer to the ground, otherwise
the helicopter is difficult to control because of its own air turbu-
lence. But also not higher, to avoid heavy damage by a crash. Move
the left lever carefully in all directions to get a feeling for the reaction
of the helicopter. Move the left stick gently to the left or right to get
a feel for the reaction of the helicopter.
4. When you have mastered the previous exercises, you can draw a
circle on the floor and try to perfect all the previous exercises in this
limited space.
5. Finally, repeat all the exercises from 1 to 4, but now place yourself
in front of the helicopter.

Getting started

Before you begin please check:
• WARNING: Only start with a sufficiently full transmitter batteries (rechargeable batteries) and fully
charged drive battery – crash hazard!
• Check all parts for damage and dirt. Replace any damaged parts and clean the model, because dirt
increases the weight and therefore can degrade the flying qualities.
• Switch on the transmitter. The red POWER LED flashes.
• Then switch on the model. The red LED on the receiver board is flashing quickly. Place the helicopter in
the start position and move the left throttle lever all the way up and then back in the lowest position. This
safety circuit prevents the rotor may start after turning ON the helicopter
• A beep indicates that the helicopter is ready. In addition, the transmitter and helicopter LED will now light
up red.
• WARNING: Always turn on the transmitter first and then the model. If this order is not followed and
you turn on the helicopter first, the binding process (see section BIND) is automatically started. This can,
26

Operation

XciteRC Flybar 190