Insert The Drive Battery; Getting Started - XciteRC Metabo RC Truggy 2WD Mode D'emploi

Insert the drive battery · Getting started

Insert the drive battery

Getting started

Make sure that the drive battery is inserted correctly and connected to the vehicle.
1. Switch the vehicle ON, switch in position ON.
2. Switch the transmitter ON.
This is needed to connect the transmitter with the reciever properly.
ON
3. Run the vehicle
Before you start, check all functions of the remote control. Does the vehicle follow exactly and directly
your commands? Or does it react delayed or choppy? If yes, do not start anyway, but check transmitter
and drive batteries and recharge or replace if necessary.
The run time of your Metabo RC-Truggy depends on the surface. The maximum run time is reached on
Metabo RC-Truggy
Note: wait until the transmitter LED stopps flashing and lights up solid.
ON
EN
19