Insert The Drive Battery; Getting Started; Driving Tips - Xciterc Rc Mini-Racebike Rtr 2,4 Ghz Red Mode D'emploi

Insert the drive battery · Getting started · Driving tips
• The LED goes out and indicates the end of the charging process, disconnect the battery from the charger.
• Unplug the USB adapter.

Insert the drive battery

Getting started

Make sure that the drive battery is inserted correctly and connected to the vehicle.
1. Switch the vehicle ON, switch in position ON.
running immediately. This is normal, because the built-in flywheel entrains the rear wheel. You can use
your fingers to stop the wheel or put the bike on the ground.
2. Switch the transmitter ON.
lights up solid. This is needed to connect the transmitter with the reciever properly.
3. Run the vehicle
Before you start, check all functions of the remote control. Does the vehicle follow exactly and directly
your commands? Or does it react delayed or choppy? If yes, do not start anyway, but check transmitter
and drive batteries and recharge or replace if necessary.
• Once you turn on the model, the flywheel in the rear wheel starts to rotate.
• Place the motorcycle on the road and keep it in place. Now give throttle and release the model.

Driving tips:

• To make a turn, make only short movements of the steering wheel. The model lies down in the curve like
a real motorcycle. To make a turn the steering wheel does not have to be kept permanently in the desired
direction - like for a car model.
RC Mini Racebike
4
WARNING: after switching ON the rear wheel starts
Note: wait about 5 sec. until the transmitter LED stopps flashing and
EN
19