Charging The Battery; Insert The Battery; Getting Started - XciteRC Buggy one10 4WD blue Mode D'emploi

Charging · Insert the battery · Getting started
• Insert the delivered BIND-plug into the receiver and turn ON the vehicle. Within 5 seconds press and hold
the PAIR button on the transmitter and turn it on. The green LED starts flashing to indicate the binding
process. After about 5 seconds, both LEDs light up continuously, the transmitter is now bound to the
One10 4WD.
•
WARNING: Never operate your model with inserted BINDING plug! Use it only during the BINDING
process - risk of crash!
• If the model cannot be controlled, repeat the process.
+
4

Charging the Battery:

Before the first use of your new model the drive battery needs to be charged.
ATTENTION: Make sure to read all safety instructions regarding the use of rechargeable batteries.
Also, if necessary, further safety instructions in the manual for your used charger.
WARNING: Charge may occur only with the supplied charger on a fireproof surface and under cons-
tant adult supervision - fire or explosion hazard!
For charging remove the battery from the vehicle.

Insert the battery

Getting started

Insert the battery into the vehicle and connect the plug to the ESC. Before you start, check all functions of
the remote control. Does the vehicle follow exactly and directly your commands? Or does it react delayed
or choppy? If yes, do not start anyway, but check transmitter and drive batteries and recharge or replace if
necessary.
The run time of your One10 4WD depends on the surface. The maximum run time is reached on a straight
and levelled surface. In hilly terrain or grass, the run time is much shorter, also the motor, speed controller
and battery gets much warmer. If the battery is weak, the vehicle first gets slower until it finally stops com-
pletely. To increase the life time of the drive battery, you should cease operation when the vehicle begins to
slow down.
1. Switch on the transmitter, ON/OFF-switch in position I.
One10 4WD
ON
1 2
Brushed
ON
3
Brushless
EN
4
21