Maintenance; Troubleshooting - XciteRC Buggy one10 4WD blue Mode D'emploi

Table des Matières

Publicité

Les langues disponibles

Les langues disponibles

EN
positive
camber
negative
camber

Maintenance

To have fun with your model over a long period, occasional service work is required to get your model in good
condition and to minimize wear.
• Remove dirt or dust depending with compressed air or a soft brush after each use. For stubborn dirt, a
harder brush or a toothbrush can be used.
• To clean the body/fuselage no chemical cleaners such as thinners may used, as this damage the plastic
of the body/fuselage. Normally a piece of soft cloth is ok, stubborn dirt can be removed with washing-up
liquid.
• Check the tightness of all screws and tighten if necessary.
• Also check all connections, cables and power battery / rechargeable battery for damage.
WARNING: Damaged batteries or rechargeable batteries must not be used again and must be
disposed of immediately – fire hazard! Please note the disposal notes at the end of this manual.
• Check the model for worn, broken or jammed parts and gears and repair if necessary.
WARNING: remove the batteries / rechargeable batteries of the transmitter and model when not in
use – fire hazard!

Troubleshooting

Problem
Motor does not
run
Vehicle runs back-
wards
24
Camber:
adjust HERE!
The tires should always have road contact with all the running tread. This
is achieved with neutral or negative camber (about 2-3 °) on both axes -
more negative camber decreases the grip level again. Ideally, the camber
is adjusted so that the tires wear is evenly.
Positive camber drastically reduces the grip and should, if at all, only be
used on the front axle, to make the cornering less aggressive.
adjust HERE!
Possible Cause
Motor cable unplugged or broken
Drive battery empty
Throttle trim TH.TRIM on the transmitter
set incorrectly
Motor broken
Throttle servo reverse switch TH.REV in
R position
Maintenance · Troubleshooting
Solution
Insert the motor cable or solder
Change or charge the battery
Check transmitter, set trim correctly
Replace the motor
Set servo reverse switch in position N
One10 4WD

Publicité

Table des Matières
loading

Ce manuel est également adapté pour:

Buggy one10 4wd brushless redTruggy one10 4wd blueTruggy one10 4wd brushless redMonster truck one10 4wd blueMonster truck one10 4wd brushless red30307000 ... Afficher tout

Table des Matières