After The Ride; Chassis Tuning Guide - XciteRC Buggy one10 4WD blue Mode D'emploi

After the ride · Chassis tuning guide
First turn the knob to the left - mimimum steering angle. Now turn the steering wheel fully to the right (or
left) and turn the adjusting knob ST.D/R slowly to the right until the desired steering angle is reached (Fig.
A). You may do this setting also while running your vehicle.
the steering arm presses against the front uprights which may damage the steering servo!
-
+

After the ride:

1. Switch OFF the vehicle first, then the transmitter (ON/OFF-switch in position O).
OFF
2. WARNING: disconnect the drive battery and remove it from the model – fire hazard!
WARNING: the motor of the One10 4WD may get very hot during operation. Allow to cool down minimum
20 minutes before the next start to avoid damage. Fire hazard!

Chassis Tuning Guide

On your One10 4WD chassis two parameters can be adjusted: the toe of the front axle and the camber of
both axles.
Front Turning Linkage Set
toe-out
zero toe
toe-in
toe-in
zero toe
toe-out
Front Turning Linkage Set
One10 4WD
+
+
Toe-in:
the setting is done via the steering linkage. More toe-in gives a better
directional stability, but also poorer turn in at corner entry, and gene-
rally a less direct steering.
More toe-out effects a direct response to steering commands and
more aggressivity at corner entry, but is also more difficult to control.
A neutral setting reduces tire wear and gives a neutral handling.
WARNING: do not turn too far, otherwise EN
A
23