After The Ride; Chassis Tuning Guide - XciteRC Sand Storm one8 2WD Mode D'emploi

Chassis tuning guide

may do this setting also while running your vehicle.
steering arm (30201011) press against the front uprights (30201012) which may damage the steering
servo!
-
+

After the ride:

1. Switch OFF the vehicle first, then the transmitter (ON/OFF-switch in position O).
OFF
2. WARNING: disconnect the drive battery and remove it from the model – fire hazard!
WARNING: the motor of the Sand Storm one8 may get very hot during operation. Allow to cool down mini-
mum 20 minutes before the next start to avoid damage. Fire hazard!
Chassis Tuning Guide
toe-out
zero toe
toe-in
toe-in
zero toe
toe-out
Sand Storm one8
+
On your Sand Storm one8 chassis two parameters can be ad-
Front Turning Linkage Set
justed: the toe of the front axle and the camber of both axles.
Toe-in:
the setting is done via the steering linkage. More toe-in gives a
better directional stability, but also poorer turn in at corner entry,
and generally a less direct steering.
More toe-out effects a direct response to steering commands
and more aggressivity at corner entry, but is also more difficult
to control.
A neutral setting reduces tire wear and gives a neutral handling.
Front Turning Linkage Set
WARNING: do not turn too far, otherwise the
+
EN
23