Installing The Flight Battery; Troubleshooting Guide - XciteRC Flybarless 200 3D V2.0 Mode D'emploi

IDLE: switch between speed and pitch control (switch position N or 0).
EN

Installing the flight battery

•
Put the throttle stick to the lowest position.
• Turn on the transmitter. Check the model memory (please see first flight preparation).
• Install the flight battery in the battery holder, connect the battery with 4-in-1 main board, place the heli-
copter static level next to the transmitter.
• Waiting several seconds, the main rotor flap up and down twice, it means the heli successfully bind to the
transmitter. Please move the heli after the binding finished.

Troubleshooting guide

Problem
LED on 3-in-1 board flashes con-
stantly and operating no function
after connecting battery to heli-
copter.
The helicopter do not response
after connecting batteries to re-
ceiver.
When push the throttle pole,the
rotor do not rotate and the LED
on Receiver flashes constantly.
Helicopter takes off immediately
once the batteries and helicopter
connected.
Turn on the helicopter after bind-
ing succasafully,the propeller ro-
tate constantly but the hellcoptar
can not take off.
18
Possible cuase
Transmitter is not bound to re-
ceiver.
Check whether the transmit- ter
and helicopter connecting to po-
wer; check the voltage of trans-
mitter and helicopter's bat- tery;
battery pole flake contact is not
good.
Low battery voltage; batteries
connection is not good.
Didn't put the throttle to the low-
est.
Low charge in aircraft batteries or
main gear loose.
Installing the Flight Battery
Solution
Bind transmitter to receiver.
Open the transmitter, make sure
the batteries connecting is good;
replace and charge transmitter
batteries, make sure the battery
pole flake contact is good.
Replace and charge the batte-
ries, reconnect the batteries to
the receiver board.
Put the throttle pole at the lowest
position before open the trans-
mitter.
Replace and charge the batter-
ies; press the spindle with gear
tightly.
XciteRC Flybarless 200 3D V2.0