Charging The Battery; Insert The Battery; Getting Started - XciteRC 30201000 Sand Rail Buggy 4WD Brushless blue Mode D'emploi

Charging · Getting started
release the BIND button. Within 5 seconds press and hold the PAIR button on the transmitter and turn it
on. The green LED starts flashing to indicate the binding process. After about 5 seconds, both LEDs light
up continuously, the transmitter is now bound to the Sand Rail.
• To save a specific failsafe position, move the steering wheel or throttle trigger to the desired position (eg.
brakes) and press the BIND button again after a successful binding procedure.
• If the model cannot be controlled, repeat the process.

Charging the Battery:

Before the first use of your new model the drive battery needs to be charged.
ATTENTION: Make sure to read all safety instructions regarding the use of rechargeable batteries.
Also, if necessary, further safety instructions in the manual for your used charger.
WARNING: Charge may occur only with the supplied charger on a fireproof surface and under cons-
tant adult supervision - fire or explosion hazard!
For charging remove the battery from the vehicle.

Insert the battery

Getting started

Insert the battery into the vehicle and connect the plug to the ESC. Before you start, check all functions of
the remote control. Does the vehicle follow exactly and directly your commands? Or does it react delayed
or choppy? If yes, do not start anyway, but check transmitter and drive batteries and recharge or replace if
necessary.
The run time of your Sand Rail depends on the surface. The maximum run time is reached on a straight and
levelled surface. In hilly terrain or grass, the run time is much shorter, also the motor, speed controller and bat-
tery gets much warmer. If the battery is weak, the vehicle first gets slower until it finally stops completely. To
increase the life time of the drive battery, you should cease operation when the vehicle begins to slow down.
1. Switch on the transmitter, ON/OFF-switch in position I.
2. Switch the vehicle ON.
to connect the transmitter with the reciever properly.
Sand Rail
1
Note: wait about 5 sec. before you move the throttle trigger. This is needed
2
ON
3
EN
4
21