Battery Charging; Charging Via Transmitter; Charging Via Usb Port; Binding - XciteRC Flybar 190 4K 2.4 GHz blue Mode D'emploi

Battery charging

WARNING: Be sure to read all safety instructions regarding the use of rechargeable batteries. Charging
EN
may take place only with the supplied charger on a fireproof surface and under constant adult supervision -
fire or explosion hazard!

Charging via transmitter

• Turn on the transmitter - switch in upper position.
• Now plug the charging adapter into the USB port on the back of the transmitter. Both charge indicator
LEDs on the adapter flashes quickly. Connect the LiPo
battery to the adapter.
• WARNING: The battery connector is polarized.
Check the side channels. Do not use force - fire or ex-
plosion hazard!
• The flashing red LED starts to light solid and displays the
charging process. Charging time is about 30 minutes. If
the battery is fully charged, the red LED turns off.
• With new transmitter batteries the helicopter battery can
be charged about 3 times (both batteries at the same
time) or up to 6 times (only one battery). Flashes the red
POWER LED, supported by a warning tone, the trans-
mitter batteries need to be changed.

Charging via USB port

• Insert the USB plug into a suitable socket on your PC or notebook (or power adapter with USB socket).
Both charge indicator LEDs on the adapter flashes quickly. Connect the LiPo battery with the adapter.
• WARNING: The battery connector is polarized. Check the side channels. Do not use force - fire
or explosion hazard!
• The flashing red LED starts to light solid and displays the charging process. Charging time is about 30
minutes. If the battery is fully charged, the red LED turns off.
The flight time of the helicopter is about 6-8 minutes.

BINDING:

The 2.4 GHz receiver of XciteRC FLYBAR 190 must be once „con-
nected" with a suitable transmitter, the so-called „binding" procedure.
This ensures that the receiver establishes a connection only with this
transmitter and the model can be operated without interference. This
process can be repeated any time.
The transmitter and receiver of the XciteRC FLYBAR 190 are already
24
connect to USB port
180 mA per set
Battery charging - Binding
XciteRC Flybar 190