Troubleshooting - XciteRC twenty4 Série Mode D'emploi

of the online spare parts list.
In case of problems or questions, please contact your dealer or:
XciteRC Modellbau GmbH & Co. KG - Service, Autenbachstrasse 12, D-73035 Göppingen, Phone +49 /
EN
7161 40 799 50
Email: service@xciterc.de
Spare parts for the twenty4 you may order in your local hobby shop or online at http://www.XciteRC.com

Troubleshooting

Problem
Motor does not
run
Weak motor / no
power
Vehicle is hard to
control
Vehicle has no
function
Vehicle runs very
loud
22
Possible Cause
Motor cable unplugged or broken
Drive battery empty
Throttle trim TH.TRIM on the transmitter
set incorrectly
Motor broken
Battery is almost empty
Throttle trim TH.TRIM on the transmitter
set incorrectly
Drive train does not run smoothly
Vehicle is very loud
Motor gets very hot
Transmitter LED flashing - transmitter
batteries almost empty
Steering trim ST.TRIM on the transmitter
set incorrectly
Interference
Throttle trim TH.TRIM on the transmitter
set incorrectly
LED on the transmitter does not light up
Throttle trim TH.TRIM on the transmitter
set incorrectly
Car aerial torn off
Transmitter LEDs flashing - transmitter
batteries almost empty
Drive battery empty
Battery contacts dirty or bent
Gear mash between the pinion and main
gear set incorrectly
Worn gears
Bearings runs tight or worn out
Troubleshooting
Solution
Insert the motor cable or solder
Change or charge the battery
Check transmitter, set trim correctly
Replace the motor
Change or charge the battery
Check transmitter, set trim correctly
Check drive train and clean if necessary
Check pinion clearance, adjust if neces-
sary
Allow motor to cool; check drive train for
binding parts and precise gear mesh
Change or charge the battery
Check transmitter, set trim correctly
Turn off the vehicle and transmitter, make
a quick break and then re-try
Set throttle trim to the center position
Check that vehicle and transmitter are
turned on
Set throttle trim to the center position
Repair antenna (vehicle)
Change or charge the battery
Change or charge the battery
Clean the contacts, re-adjust with a
screwdriver
Check gear mesh adjust if necessary
Check and replace if necessary
Check and lubricate or replace if neces-
sary
twenty4 series