Special Installation Steps; Preparing The Water Connection; Connecting The Appliance To The Water Supply; Setting The Door Opening Angle (Refrigerator Compartment) - Gaggenau RY 492 Instructions D'installation

Special installation steps

Preparing the water connection

(only for appliances which require a water connection)
Note:
Turn off the main water tap in order to avoid damage
from escaping water.
1. Attach the water line to the shut-off valve according
to the instructions supplied by the manufacturer of
the ice maker installation kit.
2. Install the water line.
Always observe the indicated dimensions to prevent
damage to the water line when pushing in the
appliance.
Connecting the appliance to the water
supply
Note:
Do not kink the connection pipe when bending it,
otherwise there is a risk of leaks and water damage.
1. Remove the cap from the appliance connection.
2. Bend the water line according to the location of the
connection on the appliance.
3. Push the union nut and seal onto the water line.
4. Push the end of the water line into the appliance
connection and screw on the union nut.
5. Using the open-ended wrench, tighten the union nut.
Do not overturn!
6. Push back the water line into the guard tube as far
as possible.
7. Open the shut-off valve and main water tap.
8. Check the connection on the shut-off valve and on
the appliance for leaks.
9. Close the shut-off valve.
Setting the door opening angle
(refrigerator compartment)
Depending on the installation situation, it may be
necessary to adjust the door opening angle. A door
opening angle of 115° has been set at the factory.
To adjust the door opening angle to 90°:
1. Open door to 90°.
2. Insert the banking pin through the boreholes which
are now vertically aligned and drive in with
a hammer.
27