Steam Cleaning With The Addition Of Disinfectant - Dirt Devil AquaClean Mode D'emploi

4 Steam cleaning
18
2
4.4 Steam cleaning with
the addition of disin-
fectant
19
MAX
1
8. To steam-clean, move the appliance back and forth
slowly.
NOTE:
1
If the steam ready indicator goes out, you can continue
working. Only if the steam produced is no longer suffi-
cient, should you release the steam button (Fig. 18/1)
and wait until the steam ready indicator (Fig. 18/2) lights
up again. Then, as required, you can wet the micro-fibre
cleaning cloth again by depressing the steam button
whilst you want to emit steam.
WARNING:
Danger of falling! Always be especially careful when
cleaning smooth floors as well as steps and stairs! Only
work with moderate amounts of steam when cleaning
smooth floors, otherwise a moisture film will be left on the
floor. Using less steam also ensures quicker drying and
reduces the risk of slipping.
ATTENTION:
Do not leave the appliance standing still when in opera-
tion. Keep it moving continuously. Otherwise there will be
increased danger of damaging the surface to be cleaned.
9. Pull out the plug just before finishing the cleaning proc-
ess and use up the remaining steam reserves.
1. Turn the disinfectant regulator (Fig. 19/1) in the MAX di-
rection according to how much disinfectant you want to
add.
2. Proceed as described in ZChapter 4.3, "Steam clean-
ing without the addition of disinfectant".
NOTE:
Disinfectant will be added to the jet of steam until the dis-
infectant tank is empty or you turn the regulator back to
the OFF position.
3. Cover each stretch of floor several times (at least 3) so
OFF
that a closed film of disinfectant is produced.
43