Steam Cleaning Using Disinfectant - Dirt Devil AquaClean Mode D'emploi

4 Use
WARNING:
Danger of scalding when interrupting work!
„
Pull the plug from the socket if you inter-
rupt work, e.g. to change attachments.
„
Wait at least ten minutes before remov-
ing the fitted attachments.

4.2 Steam cleaning using disinfectant

20
21
22
38
max
min
off
NOTE:
You can also regulate steam power and
cleaning effect by adjusting the distance to
the surface to be cleaned.
1. Check that the disinfectant tank is full. If
not, fill it (ZChapter 3.6, "Filling the disin-
fectant tank").
2. Turn the disinfectant regulator on the han-
dle according to whether you want to add
a lot of disinfectant to the jet of steam or
just a little:
- for a lot of disinfectant in the jet of
steam: 'MAX' position (Fig. 20).
- for a small quantity of disinfectant in the
jet of steam: 'MIN' position (Fig. 21).
NOTE:
Make sure that the controller clicks into the
position chosen. Positions between the
three marked positions are pointless and
obstruct problem-free function.
3. Insert the plug into a mains socket with a
ground/safety contact and proceed as de-
scribed in ZChapter 4.1, "Steam clean-
ing" .
NOTE:
Disinfectant will be added to the jet of
steam until the disinfectant tank is empty or
you turn the regulator for the addition of dis-
infectant back to
(Fig. 22).
the 'OFF' position