Uncoiling The Power Cord Quickly; Steam Cleaning Without The Addition Of Disinfectant - Dirt Devil AquaClean Mode D'emploi

4 Steam cleaning
4.2 Uncoiling the power
cord quickly
16
4.3 Steam cleaning with-
out the addition of dis-
infectant
17
5
4
3
42
WARNING:
Danger of electric shock! Always completely uncoil the
power cord. Otherwise there is a danger of underestimat-
ing the reach of the appliance, over-exerting the power
cord, and possibly damaging it.
1. Turn the upper coil storage device down and anti-clock-
wise through 180° (Fig. 16).
2. Take the entire coil from the upper and lower coil stor-
age device.
3. Secure the cable to the clip of the upper coil storage de-
vice so you do not run over it during operation.
WARNING:
Danger of scalding! Always point the steam jet down-
wards towards the surface to be cleaned. Never lay the
appliance on its side during operation. Using the appli-
6
ance in a horizontal position or even over your head is
forbidden.
1
ATTENTION:
Only use sockets whose voltage matches the voltage
given on the type plate of the appliance. Only use sock-
ets with a ground/safety contact.
1. Check that the water tank is full. If not, fill it ZChapter
3.1, "Filling the water tank".
2. Unwind the power cord (ZChapter 4.2, "Uncoiling the
power cord quickly") and secure it in the clip of the up-
per cable-storage device (Fig. 17/1).
3. Place a clean micro-fibre cleaning cloth (Fig. 17/2) on
the ground so that its two Velcro strips face upwards.
4. Now place the steam base (Fig. 17/3) exactly onto the
micro-fibre cleaning cloth. This attaches the cloth to the
appliance.
5. Insert the plug into a mains socket.
- The mains control light (Fig. 17/4) goes on.
- The appliance is now heating up.
6. Wait about 35–45 seconds until the steam ready indica-
tor (Fig. 17/5) lights up.
7. Now press the steam button (Fig. 17/6) on the handle
and keep it depressed whilst you want to emit steam.
2