Filling The Tanks; Filling The Water Tank - Dirt Devil AquaClean Mode D'emploi

3 Filling the tanks

3.1 Filling the water tank

3 Filling the tanks
10
11
Water only
12
ATTENTION:
First, pull the plug out of the plug socket. Otherwise, the
appliance might run without water and get damaged.
1. Put the appliance into the neutral position by straighten-
ing the handle until it is at about 90° to the steam base,
you can feel it lock into place, and the appliance re-
mains standing without support.
2. Hold the appliance firmly by the carrying handle and pull
the water tank up and out of the console (Fig. 10).
3. Twist the tank cap anti-clockwise and take it completely
off the tank (Fig. 11).
4. Fill the water tank with clear, cold tap water no higher
than just under the filling nozzle (Fig. 11).
WARNING:
Danger of injury! Do not add disinfectant or any other
additives such as cleaning agents, alcohol, perfumes or
chemicals into the water tank. These make use of the
appliance unsafe.
NOTE:
Do not overfill the tank. Take into consideration that the
tube at the lid also takes up some space after being
screwed on.
5. Turn the tank cap clockwise until it is completely back
on the water tank (Fig. 11).
6. Put the water tank back on powerfully (Fig. 12).
7. Check that it is securely fitted.
39