Filling The Water Tank - Dirt Devil AquaClean DD301 Mode D'emploi

3 Filling the water tank

3 Filling the water tank
4
5
6
ATTENTION:
First, pull the plug from the mains socket. Otherwise, the
appliance may run without water and become damaged.
1. Set the appliance to the neutral position by aligning the
shaft so that it is positioned approximately at a right an-
gle to the base, you can feel it click into place and the
appliance can stand up without support.
2. Hold the appliance firmly by the shaft.
3. Press the release catch ("
move it from its console at the same time (Fig. 4).
4. Screw the tank cap anti-clockwise and completely re-
move it from the water tank ("H
(Fig. 5).
5. Fill the water tank ("H
higher than the MAX mark (Fig. 6).
WARNING:
Risk of injury! Do not place any additives, such as deter-
gent, alcohol, perfumes or chemicals, in the water tank.
These make the use of the appliance unsafe.
NOTE:
Do not overfill the water tank. Remember that the hose
on the lid also takes up some space after it has been
screwed on.
6. Turn the tank cap clockwise to screw it back onto the
water tank (Fig. 5).
7. Firmly push the dual tank back into the console (Fig. 4).
8. Check that it is firmly in place.
") for the dual tank and re-
O") of the dual tank
2
O") with clear, cold tap water no
2
39