IWC Schaffhausen INGENIEUR CHRONOGRAPH Mode D'emploi page 28

— 2 8 —
T I M E S E T T I N G
Pull out the crown to position 2. This will stop the movement. To
set the time accurately to the second, it is best to stop the move­
ment as the seconds hand passes 60. Now move the minute hand
a few minute strokes beyond the time to be set. Then po sition
the minute hand by moving it gently backwards until it is exactly
above the correct minute stroke. This ensures that the minute
hand begins to move immediately when you restart the move­
ment. To start the seconds hand, push in the crown to position 0.
When setting the time, please be aware of the date change, which
always takes place at 12 midnight. If this change has already
taken place at 12 noon, you must move the hands forwards by
12 hours.
Important: Although the watch is water­resistant in positions 0,
1 and 2, the crown should always be screwed in again for normal
use to ensure the stability of the seal and to protect the winding
mechanism.
I N G E N I E U R C H R O N O G R A P H