Maintenance/Cleaning - Bosch BDU290P Notice D'utilisation D'origine

English – 10​
state of charge can be displayed for three seconds by
pressing the on/off button (10) on the eBike battery.
Disconnect the charger from the mains and the bat-
tery from the charger.
When the battery is disconnected from the charger,
the battery is automatically switched off.
Note: If you have charged the battery on the bike,
carefully close the charging socket (6) with the cover
(7) after charging, so that no dirt or water can get in.
If the charger is not disconnected from the battery af-
ter charging, the charger will switch itself back on af-
ter a few hours, check the state of charge of the bat-
tery and begin the charging process again if neces-
sary.

Maintenance/cleaning

Do not open any of the components. Service
u
should only be carried out at an authorized
Bosch eBike dealer. Failure to follow above warn-
ing can cause death or serious injury. Refer to your
bicycle manual or component manual for all non-
Bosch drive system components.
Do not charge or use your eBike in any area with
u
a potentially explosive atmosphere, such as at a
fueling area, or in areas where the air contains
chemicals or particles (such as grain, dust, or
metal powders). Obey all signs and instructions.
Do not submerge your eBike components in wa-
u
ter, or wash with pressurized hose. Your Bosch
drive unit is designed to be water tight to rain water
or non-pressure hose washing.
Do not paint any components of the Bosch drive
u
system as they may cause premature failure of
the component.
After-sales service and advice on using
products
If you have any questions about the eBike system and
its components, contact an authorized bicycle dealer.
0 275 U07 XCX | (11.01.2019)
For contact details of authorized bike dealerships,
please visit www.bosch-ebike.com.
Please contact an authorized bicycle dealer if the bat-
tery is no longer working.
254
Bosch eBike Systems