Operation; Switching On/Off; Transport; Maintenance/Cleaning - Bosch BDU290P Notice D'utilisation D'origine

Masquer les pouces Voir aussi pour BDU290P:
Table des Matières

Publicité

Les langues disponibles

Les langues disponibles

Operation

Start-up
Use only original Bosch batteries that the manu-
u
facturer has approved for your eBike. Using
other batteries can lead to injuries and pose a fire
hazard. Bosch accepts no liability or warranty
claims if other batteries are used.

Switching on/off

Switching on the battery is one way to switch on the
eBike system. Read and follow the instructions in the
operating manuals for the drive unit and on-board
computer.
Before switching on the battery, i.e. the eBike sys-
tem, make sure that the lock (6) is closed.
To switch on the battery, press the on/off button (4).
Do not use sharp or pointed objects to press the but-
ton. The LEDs on the indicator (3) will light up, indi-
cating the battery's state of charge at the same time.
Always check that the battery pack is locked in
u
place. To do this, pull on the battery pack (after the
key has been removed).
Note: If the battery capacity is less than 5 %, none of
the LEDs on the battery charge indicator (3) will light
up. The only way to see if the eBike system is
switched on is via the on-board computer.
To switch off the battery, press the on/off button (4)
again. The LEDs on the indicator (3) go out. This will
also switch the eBike system off.
If no power is drawn from the eBike drive for about
ten minutes (e.g. because the eBike is not moving)
and no button is pressed on the on-board computer
or the operating unit of the eBike, the eBike system,
and therefore also the battery, will switch off auto-
matically to save energy.
The battery is protected against deep discharge,
overloading, overheating and short-circuiting by the
"Electronic Cell Protection (ECP)". In the event of
danger, a protective circuit switches the battery off
automatically.
Bosch eBike Systems

Transport

Always remove the battery pack from the bicy-
u
cle before transporting the bicycle on a vehicle
bike rack. Failure to remove the battery pack when
using a vehicle bike rack can lead to death or seri-
ous injury. The battery may detach during transport
and cause an accident to following vehicles.
Always use an approved and compatible bicycle
u
rack when transporting your eBike. The Bosch
drive system adds weight to the bicycle. Refer to
your bicycle rack manual to be sure your eBike is
compatible. Overloading a bike rack can result in
death or serious injury.
Use proper lifting techniques as electric bikes
u
are generally heavier than bicycles.
Ship batteries only when the housing is undamaged.
Tape or mask off open contacts and pack up the bat-
tery in such a manner that it cannot move around in
the packaging. Inform your parcel service that the
package contains dangerous goods. Please also ob-
serve possibly more detailed national regulations. Al-
ways check state and federal regulations before at-
tempting to ship your battery.
If you have any questions about transporting the bat-
teries, contact an authorized bicycle dealer. You can
also order suitable transport packaging from the
dealer.

Maintenance/cleaning

Do not open any of the components. Service
u
should only be carried out at an authorized
Bosch eBike dealer. Failure to follow above warn-
ing can cause death or serious injury. Refer to your
199
English – ​ 1 3
If a fault is detected in the
battery, two of the LEDs
on the battery charge in-
dicator (3) will flash. Con-
tact an authorized bicycle
dealer if this happens.
0 275 U07 XPX | (10.01.2019)

Hide quick links:

Publicité

Table des Matières
loading

Table des Matières