Elite Super Crono Notice D'utilisation page 28

GB
weight and pass on to the next screen.
Unit type choosing screen.
This screen is used to choose the resistance unit
type. To correctly set the computer for the super
Crono Wireless set number "3". This number
should already be set, in case it isn't, press the
SET
button until the digit turns to 3. Push the MODE
button to go out of the SET UP screen.
ATTENTION: A wrong TYPE number leads to the
wrong calculation and display of data.
Example: If you want to set the unit as Kg,
Meters, Km, as weight 78 Kg and type 3, you will
have to follow the steps as follows:
To enter the SET UP screen press the MODE
button for 3 seconds. Press the SET button until
on the screen appears the following: METER,
actual values
28
average values
Mode
KILO e KM/H. Press the MODE button. Press the
SET button until the digit that blinks (the one on
the rightmost part) becomes an "8". Press the
MODE button. Press the SET button until the digit
that blinks (the central one) becomes "7". Press
the MODE button. Press the SET button until the
digit on the leftmost part becomes "0". Press the
MODE button. Press the SET button until the
blinking digit becomes "3". Press the MODE but-
ton.
End of set up.
USAGE
During the training there are three different scre-
ens available. Each screen is divided in six areas
with information that varies between the screens
you may choose from.
During the race there is the chance to pass from
one screen to another to review the data that has
the most relevance. To do this press the MODE
button (fig. 36).
TO START A RUN
To run on the computer simply press SET or
MODE.
max values
Mode Mode