Troubleshooting - Ryobi RYAC800 Manuel D'utilisation

IF THESE SOLUTIONS DO NOT SOLVE THE PROBLEM CONTACT YOUR AUTHORIZED SERVICE DEALER.
PROBLEM
Snow shovel not starting.
The motor is on but the impeller does
not turn.
After passing, the snow shovel leaves a
layer of snow on the ground.

TROUBLESHOOTING

POSSIBLE CAUSE
Snow shovel is unplugged.
The lock-out button was not depressed.
The drive belt is worn or broken.
The impeller/scraper mechanism is
worn.
MAKE THE MOST OF YOUR PURCHASE!
Go to http://register.ryobitools.com and register your new tool on-line.
Your product has been fully tested prior to shipment
to ensure your complete satisfaction.
For any questions about operating or maintaining
your product, call the Ryobi
12 — English
SOLUTION
Connect snow shovel to power supply.
Depress the lock-out button, then fully
depress the switch trigger.
Have the drive belt replaced by an au-
thorized service center.
Have the impeller/scraper mechanism
replaced by an authorized service
center.
Help Line!
®