Changing The Dust Compartment Filter; When To Replace The Exhaust Filter; How To Replace The Airclean Filter; Replacing The Active Airclean 50 And Hepa Airclean 50 Exhaust Filters - Miele SGDE0 Instructions D'utilisation

en

Changing the dust compartment filter

(Fig. 38)
 Open the dust compartment lid.
 Pull the FilterBag out by the grip on
the collar.
 Open the blue filter frame fully and
remove the old filter. Hold by the
clean, unsoiled section to remove it.
 Replace with a new dust compart-
ment filter (for motor protection).
 Close the filter frame.
 Insert the FilterBag into the blue
holder as far as it will go.
 Close the dust compartment lid se-
curely, making sure it clicks into posi-
tion. Take care not to trap the Fil-
terBag when doing so.

When to replace the exhaust filter

Depending on the model, your vacuum
cleaner will come with one of the fol-
lowing exhaust filters (Fig. 09) as stan-
dard:
a AirClean
Replace this filter every time you start a
new packet of Miele FilterBags. An Air-
Clean exhaust filter is supplied with ev-
ery packet of Miele FilterBags.
b Active AirClean 50 (black)
c HEPA AirClean 50 (white)
Replace if the display for the exhaust fil-
ter change indicator is completely filled
with red (Fig. 14). This occurs after ap-
prox. 50 hours of operation which is
equivalent to about a year of average
use. The vacuum cleaner can still be
used.
22
However, the suction power will be re-
duced as will the effectiveness of the fil-
ter if it is not replaced in good time.

How to replace the AirClean filter

(Figs. 39 + 40)
Do not use more than one exhaust fil-
ter at a time.
 Open the dust compartment lid.
 Press the release catch on the filter
grille and open the grille until it clicks.
 Grasp the used AirClean exhaust filter
by one of the clean, unsoiled sections
and take it out.
 Replace it with a new AirClean ex-
haust filter.
If you wish to fit an Active AirClean
50 or HEPA AirClean 50 exhaust fil-
ter, see "Replacing one type of ex-
haust filter with another."
 Close the filter frame.
 Close the dust compartment lid.
Replacing the Active AirClean 50 and
HEPA AirClean 50 exhaust filters
(Figs. 41 + 42)
Do not use more than one exhaust fil-
ter at a time.
 Open the dust compartment lid.
 Lift the exhaust filter and remove it.
 Insert a new exhaust filter, making
sure it goes in properly, then push it
down into position.
 Press the TimeStrip exhaust filter
change indicator (Fig. 12).