DeWalt DCF610 Guide D'utilisation page 13

3. Hold tool firmly with both hands to control the twisting action of the
tool.
WARNING: The screwdriver may stall if overloaded causing a
sudden twist. Always expect the stall. Grip the screwdriver firmly with
both hands to control the twisting action and avoid injury.
4. IF THE SCREWDRIVER STALLS, it is usually because it is
being overloaded or improperly used. RELEASE TRIGGER
IMMEDIATELY, remove bit from work, and determine the cause
of stalling. DO NOT CLICK TRIGGER ON AND OFF IN AN
ATTEMPT TO START A STALLED SCREWDRIVER — THIS
CAN DAMAGE THE SCREWDRIVER.
5. To minimize stalling or breaking through the material, reduce
pressure on the screwdriver and ease the bit through the last
fractional part of the hole.
6. Keep the motor running when pulling the bit back out of a hole.
This will help prevent jamming.
7. With variable speed screwdrivers, there is no need to center
punch the point to be drilled. Use a slow speed to start the hole
and accelerate by squeezing the trigger harder when the hole is
deep enough without the bit skipping out.
MAXIMUM RECOMMENDED CAPACITY
BITS DRILLING
MAINTENANCE
WARNING: To reduce the risk of serious personal injury,
place the forward/reverse button in the lock-off position or
turn tool off and disconnect battery pack before making any
adjustments or removing/installing attachments or accessories.
Cleaning
at least once a week. To minimize the risk of eye injury, always wear
ANSI Z87.1 approved eye protection when performing this.
cleaning the non-metallic parts of the tool. These chemicals may
weaken the plastic materials used in these parts. Use a cloth
dampened only with water and mild soap. Never let any liquid get
inside the tool; never immerse any part of the tool into a liquid.
CHARGER CLEANING INSTRUCTIONS
outlet before cleaning. Dirt and grease may be removed from the
exterior of the charger using a cloth or soft non-metallic brush. Do not
use water or any cleaning solutions.
Accessories
have not been tested with this product, use of such accessories with
this tool could be hazardous. To reduce the risk of injury, only D
recommended accessories should be used with this product.
Recommended accessories for use with your tool are available
at extra cost from your local dealer or authorized service center. If
you need assistance in locating any accessory, please contact
3/8" (.95 cm)
D
21286, call 1-800-4-D
www.dewalt.com.
Repairs
The charger and battery pack are not serviceable. There are no
serviceable parts inside the charger or battery pack.
11
WARNING: Blow dirt and dust out of all air vents with clean, dry air
WARNING: Never use solvents or other harsh chemicals for
WARNING: Shock hazard. Disconnect the charger from the AC
WARNING: Since accessories, other than those offered by D
WALT Industrial Tool Co., 701 East Joppa Road, Baltimore, MD
E
WALT (1-800-433-9258) or visit our website
E
WALT,
E
WALT
E