Listening To Station Presets; Naming Preset Stations - Pioneer VSX-519V Mode D'emploi

Using the tuner
1 Tune to a station you want to memorize.
See Listening to the radio on page 40 for more
on this.
2 Press TUNER EDIT.
The display shows PRESET, then a blinking
MEM and station preset.
Press PRESET / to select the station
3
preset you want.
You can also use the number buttons.
4 Press ENTER.
After pressing ENTER, the preset number stop
blinking and the receiver stores the station.

Listening to station presets

You will need to have some presets stored to do
this. See Saving station presets on page 40 if
you haven't done this already.
Press PRESET / to select the station
1
preset you want.
• You can also use the number buttons on
the remote control to recall the station
preset.

Naming preset stations

For easier identification, you can name all of
your preset stations.
1 Choose the station preset you want to
name.
See Listening to station presets above for how
to do this.
2 Press TUNER EDIT twice.
The cursor at the first character position is
blinking on the display.
3 Input the name you want.
Choose a name up to eight characters long.
• Use the PRESET / buttons to select
character position.
• Use the TUNE / buttones to select
characters.
• The name is stored when ENTER is
pressed.
Tip
• To erase a station name, follow steps 1
and 2, and press ENTER while the display
is blank. Press TUNER EDIT while the
display is blank, to keep the previous
name.
• Once you have named a station preset,
Press DISPLAY to show the name. When
you want to return to the frequency
display, press DISPLAY several times to
show the frequency.
08
41
En