Connecting An Ir Receiver - Pioneer VSX-519V Mode D'emploi

03 Connecting up

Connecting an IR receiver

If you keep your stereo components in a closed
cabinet or shelving unit, or you wish to use the
sub zone remote control in another zone, you
can use an optional IR receiver (such as a Niles
or Xantech unit) to control your system instead
of the remote sensor on the front panel of this
1
receiver.
1 Connect the IR receiver sensor to the
IR IN jack on the rear of this receiver.
For more information on connecting the IR
receiver, see the Installation Instructions for
the IR Receiver.
Note
1 • Remote operation may not be possible if direct light from a strong fluorescent lamp is shining on the IR receiver remote
sensor window.
• Note that other manufacturers may not use the IR terminology. Refer to the manual that came with your component to check
for IR compatibility.
• If using two remote controls (at the same time), the IR receiver's remote sensor takes priority over the remote sensor on the
front panel.
20
En