Publicité
Les langues disponibles
Les langues disponibles
2. Rotate the shroud into the desired working position. The
shroud should be positioned between the spindle and
the operator to provide optimum efficiency.
3. Tighten the collar screw
11
shroud on the gear case. Do not operate the grinder
with a loose tuckpoint shroud.
4. To remove the tuckpoint shroud, loosen the collar
screw, rotate the tuckpoint shroud to align the slots and
tabs and pull up on the tuckpoint shroud.
nOTE: The tuckpoint shroud is pre-adjusted to the diameter
of the gear case hub at the factory. If, after a period of time,
the tuckpoint shroud becomes loose, tighten the collar
screw
11
.
NOTICE: If tuckpoint shroud cannot be secured by
tightening the collar screw, do not use tool. Take the
tuckpoint shroud to a service center to repair
tool and
or replace the tuckpoint shroud.
Flanges and Wheels
CAUTION: Turn unit off and unplug the tool before
making any adjustments or removing or installing
attachments or accessories.
Mounting Non-Hubbed Wheels (Fig. C)
WARNING: Failure to properly seat the flanges and/or
wheel could result in serious injury (or damage to the
tool or wheel).
WARNING: A closed, two-sided cutting wheel guard is
required when using diamond coated cutting wheels.
WARNING: Use of a damaged flange or guard or
failure to use proper flange and guard can re sult in
injury due to wheel breakage and/or wheel contact.
See the Accessories Chart for more information.
It may be necessary to open the cornering door to install
tuckpointing wheels, see Cornering Door Application.
1. Place the tool on a table, guard up.
2. Install the unthreaded backing flange
with the raised center (pilot) facing the wheel.
3. Place wheel
against the backing flange,
17
centering the wheel on the raised center (pilot) of the
backing flange.
4. While depressing the spindle lock button and with the
hex depressions facing away from the wheel, thread the
threaded locking flange
4
engage the two slots in the spindle.
5. While depressing the spindle lock button, tighten the
threaded locking flange
4
6. To remove the wheel, depress the spindle lock button
and loosen the threaded locking flange.
to secure the tuckpoint
3
on spindle
1
on spindle so that the lugs
using a Hex wrench.
Fig. C
Depth of Cut Adjustment (Fig. D)
1. Loosen the depth of cut shoe locking knob
2. Slide the depth of cut shoe
3. Tighten depth of cut shoe locking knob.
Fig. D
Corner Door Application (Fig. E)
WARNING: To reduce the risk of injury, ALWAYS
turn off tool and disconnect the tool from the
power source before making any adjustments
or removing or installing attachments or
accessories. This applies to both the grinder and
the dust extractor vacuum. Such preventative
safety measures reduce the risk of starting the
tool accidentally.
WARNING: Risk of personal injury. The corner door
should only be opened for cutting inside corners. Keep
hands and body away from cutting area at all times.
Ensure corner door is closed in all other applications.
This feature allows the cutting of an inside corner.
1. Ensure the tool is off and wheel has come to a
complete stop.
2. Turn cornering door locking lever
one full rotation. Grasp the corner door
open as shown in Figure E.
3. Place hands away from the wheel area and position
yourself so the open underside of the shroud is facing
away from you.
4. Turn the tool on and allow the tool to reach full speed
before touching the tool to the work surface.
English
4
17
3
1
13
.
to the desired position.
12
12
13
14
counterclockwise
9
and rotate
7
Publicité
