Hitachi DS 18DGL Instructions De Sécurité Et Mode D'emploi page 17

CAUTION
●
The motor rotation may be locked to cease while
the unit is used as drill. While operating the driver
drill, take care not to lock the motor.
●
When setting the shift knob to "HIGH" (high
speed) and the position of the clutch dial is "17"
to "22", it may happen that the clutch does not
engaged and that the motor is locked. In such a
case, please set the shift knob to "LOW" (low
speed).
●
If the motor is locked, immediately turn the power
off. If the motor is locked for a while, the motor or
battery may be burnt.
●
Too long hammering may cause the screw broken
due to excessive tightening.
●
A buzzing noise is produced when the motor is
about to rotate; This is only a noise, not a machine
failure.
7. Using the light
Pull the trigger switch to light up the light. The light
keeps on lighting while the trigger switch is being
pulled. The light goes out after releasing the trigger
switch. (Fig. 11).
Light
CAUTION
Do not look directly into the light. Such actions
could result in eye injury.
8. Using the hook (sold separately)
The hook is used to hang up the power tool to your
waist belt while working.
CAUTION
●
When using the hook, hang up the power tool
firmly not to drop accidentally.
If the power tool is dropped, it may lead to an
accident.
●
When carrying the power tool with hooked to your
waist belt, do not fit any bit to the tip of power
tool. If the sharp bit such as drill is fitted to the
power tool when carrying it with hooked to your
waist belt, you will be injured.
Switch
trigger
Fig. 11
●
Install securely the hook. Unless the hook is securely
installed, it may cause an injury while using.
(1) Placing the hook and tightening the screws.
Install securely the hook in the groove of power
tool and tighten the screws to fix the hook firmly.
(Fig. 12)
Hook
(2) Removing the hook.
Remove the screws fixing the hook with Philips
screw driver. (Fig. 13)
English
Groove
Screw
Fig. 12
Screw
Hook
Fig. 13
17