Lamp Timer Reset; Interpolation; Status Message Contrast; Color Space Converter - Sony SRX-R110 Manuel D'installation

elements each.
When you click the B
move a blue picture element right or left up to two
elements each.
V: Moves the picture elements vertically.
When you click the R
move a red picture element up or down up to two
elements each.
When you click the B
move a blue picture element up or down up to two
elements each.
Notes
The following symptoms appear on the displayed picture
after you have moved the picture elements:
– In single-screen mode with four signal sources input,
two picture elements each on the upper, lower, left and
right sides may be invisible as the visible aspect ratio is
4092 × 2156 dots.
– In dual-screen mode with two signal sources input, two
picture elements each on the left and right sides are not
visible, and a black vertical line may appear in the center
of the screen.
– In quad-screen mode with four signal sources input, two
picture elements each on the upper, lower, left and right
sides are not visible, and black vertical and horizontal
lines may appear in the center of the screen.

LAMP TIMER RESET

The used hours of Lamp A and Lamp B are displayed.
Clicking the RESET button resets the time to "0H." Reset
the time after replacing the lamp with a new one.

INTERPOLATION

When projecting a 2K-resolution image, set to "On." You
can obtain high-resolution picture quality with a smooth
image.
When set to "Off," the projected image appears rough.

STATUS MESSAGE CONTRAST

Adjusts the contrast of the STATUS MESSAGE window
on the left side of the projector.

COLOR SPACE CONVERTER

The color characteristics of the projector can be corrected
for each color gamut, "709" or "DCDM."
26
GB
SERVICE Window
or button, you can
or button, you can
or button, you can
For details on the procedures, see "Correcting the Color
Characteristics (Color Space Converter)" on page 27.

VERSION INFORMATION

Displays the version information on this projector.