Télécharger Imprimer la page

Connecting The Projector; Connecting With Hd-Sdi Equipment; Connecting With Component/Video Gbr Equipment - Sony SRX-R110 Manuel D'installation

Masquer les pouces Voir aussi pour SRX-R110:

Publicité

Les langues disponibles

Les langues disponibles

Connecting the Projector

When you connect the projector, make sure to:
• Turn off all equipment before making any connections.
• Use the proper cables for each connection.
• Insert the cable plugs firmly; loose connections may
increase noise and reduce performance of picture
signals. When pulling out a cable, be sure to pull it out
from the plug, not the cable itself.
• When installing the optional input board, consult with
the Sony dealer.
Refer also to the instruction manuals of the equipment to
be connected.

Connecting with HD-SDI Equipment

Attach the optional LKRI-002 HD-SDI (4:2:2) or LKRI-
003 HD-SDI (4:4:4) input board to the input board
attachment part, and connect the HDCAM recorder/player.
The illustration below shows an example with the LKRI-
002.
Left side
INTER LOCK ETHERNET
RS232C
HDCAM recorder/player, etc.
18
GB
Connecting the Projector
IN
OUT
IN
OUT
IN connector
HD-SDI connecting cable
(not supplyed)
to HD-SDI output
SRW-5000
HD DIGITAL VIDEO CASSETTE RECORDER
Note
When the LKRI-003 is attached to the projector, select the
type of signal with "Signal Mode" of "Input Source" in the
PICTURE CONTROL window. For Single-link input,
select "YPbPr" or "YPbPr FULL." For Dual-link input,
select "RGB" or "RGB FULL."
For details, see page 21.
Connecting with Component/Video
GBR Equipment
Attach the optional LKRI-001 analog input board to the
input board attachment part on the projector, and connect
with a DVD recorder/player or analog video equipment
equipped with the component output, or an high-definition
equipment equipped with a video GBR connector.
Left side
INTER LOCK ETHERNET
RS232C
Betacam, DVD recorder/player, etc.
Note
When connecting to the output of component equipment,
set "Signal Mode" of "Input Source" in the PICTURE
CONTROL window to "YPbPr," and when connecting to
the video GBR output of an HD equipment, set to "RGB."
For details, see page 21.
R(P
r
/C
r
)
G(Y/Y)
B(P
b
/C
b
)
HD
VD
R(P
r
/C
r
)
G(Y/Y)
B(P
b
/C
b
)
HD
VD
IN
OUT
IN
OUT
R/P
/ G/Y / B/P
r
b
connectors
Component cable, etc
(not supplied)
to component output/
video GBR

Publicité

loading

Ce manuel est également adapté pour:

Srx-r105