Displaying The Control Function Menu Window - Sony SRX-R110 Manuel D'installation

Adjustments and Settings
Using the SRX Controller
Displaying the Control
Function Menu Window
When you install the supplied SRX Controller in a
computer, you can operate the picture adjustments, input
signal settings, installation settings, etc. from the
computer.
Some of the picture adjustments are available using the
supplied Remote Commander.
1
Double-click the
desktop window of the computer.
The Browser Screen window appears.
2
Select the projector you want to operate by double-
clicking the projector or click the Select button.
The Control Function Menu window opens.
3
Click any of the PICTURE CONTROL, COLOR/
FRAME and INSTALLATION buttons to display the
desired control window.
20
GB

Displaying the Control Function Menu Window

icon of the application in the
Chapter
For details on each setting window, see the relevant
window pages.
To go back to the Browser Screen
Select "Back" on the menu bar.
To clear the Control Function Menu
window
Select "Quit" from the File menu on the menu bar, or click
the (close) button.
To reset the settings that have been
adjusted
Clicking the RESET button in the PICTURE CONTROL
window resets all the settings of the items for "Signal
Adjust" to their factory preset values. To reset the settings
of the items for "Frame Adjust" in the COLOR/FRAME
window, click the RESET button in the COLOR/FRAME
window.
To register the settings that have been
adjusted
You can register the settings that have been adjusted in the
control windows to FUNCTION 1 to 7. As the default
setting, the settings are registered to FUNCTION 1. To
register the settings to FUNCTION 2 to 7, click one of the
FUNCTION 2 to 7 radio buttons, then adjust the items in
each window.
You can recall it later to project the picture with the desired
setting by clicking one of the FUNCTION radio buttons.
You can also recall the settings registered to the
FUNCTION 1, 2 or 3 button with the FUNCTION 1, 2 or
3 button on the Remote Commander.
Note
When you click the FUNCTION button to switch to
another FUNCTION setting, the picture will be cut off for
up to about 10 seconds. The picture with the selected
FUNCTION setting will then appear on the screen.
For details on the items that can be registered, refer to the
Operating Instructions of this projector.
4