Frame Adjust; Installation Window; Lens Control; Electric V Shift Function - Sony SRX-R110 Manuel D'installation

"CUSTOM4." "DCI W/P" is preset in CUSTOM1 to
4 settings in the factory.
"6500" is recommended for a normal high-definition
signal or RGB signal. Set this item to "DCI W/P" to
project a movie source.
Gamma: Selects a gamma correction curve from among
"2.6," "2.2" and "1.8."
The smaller the value, the brighter the image. Select
the setting depending on the signal source. "2.2" is
recommended to project a normal high-definition
signal or RGB signal.

Frame Adjust

Adjusts the horizontal size and the position of the picture.
Clicking increases the setting value, and
decreases it.
Clicking the RESET button resets all the settings of
"Frame Adjust" to the factory-preset values.
Dot Phase: Adjusts the phase of the SXRD panels and the
input signal. Adjusts the value to obtain the clearest
picture.
H Size: Adjusts the horizontal size of the picture according
to the input signal. As the setting value increases, the
horizontal size of the picture becomes larger.
H Shift: Adjusts the horizontal position of the picture. As
the setting value increases, the picture moves to the
right. As the value decreases, the picture moves to the
left.
V Shift: Adjusts the vertical position of the picture. As the
setting value increases, the picture moves up. As the
value decreases, the picture moves down.
Notes
• Adjustment of "Dot Phase" and "H Size" is available for
computer signal input only.
• If the position of the picture is not adjusted correctly,
noise may appear in the blank portion of the screen. This
is not a malfunction of the projector. Adjust the picture
position correctly with "Frame Adjust."

INSTALLATION Window

The INSTALLATION window is used to adjust the
projected picture, change the lamp output, etc.

LENS CONTROL

Adjusts the projected picture on the screen.
Zoom +/–: Adjusts the size of the picture. Clicking
enlarges the picture size, and
size.
Focus +/–: Adjusts the picture focus. Clicking
on a picture further back. Clicking
forward picture.
Shift +/–: Adjusts the vertical position of the picture.
Clicking moves the picture upward. Clicking
moves it downward.

ELECTRIC V SHIFT FUNCTION

Adjusts the vertical position of the projected pictures
electrically. As the setting value increases, the picture
moves upward. As the setting value decreases, the picture
moves downward.
Clicking the RESET button resets the setting to the
factory-preset values.
Notes
• This function is effective in the following cases:
- When single-screen mode is selected
- When quad-screen mode is selected, in which a signal
from INPUT A is projected on the upper left window,
that from INPUT B on the upper right window, that
from INPUT C on the lower left window and that from
INPUT D on the lower right window, when the input
signal frequencies are 24/23.98 Hz and when
"PROGRESSIVE DISPLAY MODE" is set to "On".
- When the optional LMT-100 Media Block is
connected to the projector
• When this function is used for quad-screen mode, all the
projected signals should be genlocked to synchronize
reduces the picture
focuses
focuses on a
23
INSTALLATION Window
GB