Publicité
Les langues disponibles
Les langues disponibles
Control on the hood:
① switch on / off
② decrease speed levels
③ increase speed levels
④ illumination
⑤ Speed 1,2,3 indicator lamps
⑥ Powerspeed indicator lamp
3.1 Extraction
Switch on – switch off
To switch the motor on push button ①.
The hood will always resume the level it was previously
switched off in.
Switch off with 30 minute delay:
Press button ① once. The first green Speed indicator
lamp blinks, the other Speed indicator lamps remain lit
up according to the level in use. After 30 minutes motor
and illumination switch off automatically.
Switch off without delay:
Push button ① twice.
Auto-Stop
To avoid that the hood will function during a too long
period, it will switch off automatically after 3 hours
(when no changes to the controls have been made).
Only the motor will turn off automatically. The lighting
will stay on.
Motor speed
To decrease speed levels push button ②. To increase
speed levels push button ③.
Three green Speed indicator lamps ⑤ indicate level 1 to
3, one red Speed indicator lamp ⑥ indicates the level
'POWER'.
'POWER' is only used in case of excessive formation of
smoke, fumes or odours. Taking into account the large
volume of air which is extracted from the room at this
level, it's use should be limited.
'POWER' automatically reverts to level 3 after 6 min-
utes.
A self-rectifying thermal contact makes sure that
the motor is switched off when overheated. The mo-
tor will switch on again after is has cooled down. The
cause of the overheating needs to be determined. This
may be, for example, that the contents of the pan have
caught fire, the motor fan is blocked or an object is
(partly) closing off the exhaust opening.
3.2 llumination
To activate the lights press button ④. The lights will
switch on at full power.
Lighting can be activated independently from the mo-
tor.
4 MAINTENANCE
4.1 Grease filter
Maintenance of the grease filter
The hood contains two metal filters which should be
cleaned twice a month.
Grease filter indication
Indication: 4 flashing indicator lamps
After 20 cooking hours, the 4 indicator lamps will start
to blink during 5 minutes, this indicates that the grease
filter has to be cleaned.
Access to the filter
Grip the glass plate (A) at the bottom left and right and
pull it forwards. Open the glass plate so that the grease
filter is visible. You can remove the metal grease filter
(B) from the hood.
Cleaning the filter
• in the dishwasher
• manually: in a hot solution of water and a liquid de-
tergent.
Rince and allow to dry completely
The previous instructions need to be followed. If
not an increased fire hazard may occur.
Reset grease filter indication
When replacing the cleaned filter, you have to reset the
hood by pushing the [–] button during 5 seconds. If you
don't reset, the indicator lamps will continu blinking.
We advise you to clean your filter twice a month for an
optimal operation.
4.2 Recirculation
The hood has one monoblock filter. Use only the Novy
monoblock filter in the hood.
Cleaning indication
Indication: red indicator lamp lights up
The red indicator lamp will light up after 200 working
hours (time to regenerate the Monoblock recirculation
filter). The recirculation filter is to be found behind the
grease filter.
EN 15
Publicité
