Lighting; Cleaning And Maintenance; General Maintenance; Grease Filter - Novy Vision 7830 Mode D'emploi

To decrease the power level press key
− Three green LEDs 5 show positions one to three.
6
− The red LED shows the Power position. The Power
position is only used if there are strong odours, or a lot
of smoke or vapour. Its use must be kept to a minimum
because of the large extraction of air in this position.
− The Power position automatically goes back to speed
three after 6 minutes.
− The motor has a thermal switch that switches the motor
off with overheating. After cooling the motor will switch
on again.


Determining the cause of overheating is re-
quired. This can be caused for example by a
pan fi re, the impeller motor being blocked or
an object getting in the exhaust opening and
causing it to be partly or fully blocked.
Auto-Stop
To avoid the extractor hood from staying on, the motor is
automatically switched off after 3 hours (only if in 3 hours
operation has not been changed). The extractor hood
lighting stays on.

2.3 Lighting

Turning the lighting on and off
To turn the lighting on or off press
The light works independent of the motor.
.
2
.
4
– 30 –

3 CLEANING AND MAINTENANCE

Follow all instructions as described in the Con-
ditions for Safety and Use section.


Follow the cleaning instructions below for a
longer working life and optimal operation of the
appliance.


The bottom panel, grease fi lter and recircula-
tion fi lter can fall out when you are handling
them. This can result in damage. Make sure you
hold the bottom panel and the fi lter(s) securely
at all times when handling them.


WARNING! Risk of injury! Open and close the
bottom panel slowly. Use a stable stepladder
and pay attention to stability. Do not step on the
hob or the worktop surface.

3.1 General maintenance

Allow the lighting to cool down suffi ciently be-
fore you start cleaning the extractor hood.


Never use aggressive, abrasive or chlorinated
products.


Do not use a high pressure or steam cleaner.
Stainless steel
Clean with a cleansing tissue with mild cleaning agent
then dry with a soft cloth. Maintenance of the stainless
steel can be performed with the Novy cleaner (906060).
Coated parts of the extractor hood
The extractor hood can be cleaned with a damp cleansing
tissue and a mild cleaning agent.
Glass
Glass parts of the extractor hood can be cleaned with
a soft cloth and a glass cleaner.
3.2 Grease fi lter


If the following instructions are not carried out,
serious soiling can cause a fi re hazard.