Replacing The Led Lighting; Electrical Connection - Novy 6835/15 Mode D'emploi Et D'installation

• Take the filter from the hood.
• Take the Monoblock recirculation filter from
the hood.
ATTENTION: Do not pull the fabric of the
Monoblock filter!
Regenerate the Monoblock recirculation filter:
• The Monoblock can be regenerated up to 12
times. This is done in the oven.
• Place the filter in the oven for 1 hour at 120°C.
Provide sufficient fresh air in the room where
the oven has been placed, as smells can be
released. Smells can be released when baking
certain kinds of fish. The best solution for this
is to immediately regenerate the filter.
Reprogramming:
Press + and – simultaneously for 5 seconds,
the red speed indicator lamp flashed 3 times for
confirmation (if this programming is not done, the
program will be set automatically after having
switched on the device 10 times).
Deactivate the program:
Simultaneously press + and – for 5 sec. until the
third green speed indicator lamp flashes 3 times.
Maintenance of the hood
Please allow the lights to cool down sufficiently
before cleaning the hood.
Use a soft, wet cloth and a mild detergent to
clean the hood.
Never use aggressive, abrasive detergents or
sponges. Bleach will damage stainless steel.
The stainless steel surfaces can be treated with
Novy Inoxcleaner (906.060) after cleaning.

Replacing the led lighting

First, remove the power supply from the hood
and allow the lighting to cool down sufficiently.
1. Carefully press the spotlight holder; next,
remove the spotlight holder by means of a tilting
movement.
2. Removing the LED lamp:
A. First disconnect the cable to the LED to be
replaced. Disconnect by means of releasing
the lock, by applying light pressure while at
the same time pulling away.
B. Next, remove the LED to be replaced by
making a gentle rotating movement to the left.
3. Mounting the new LED:
A. Place the new LED light into the locking ring.
B. Make a rotating movement to the right until the
LED light is locked.
C. Connect the power cable.
D. Place the spotlight holder back in the cooker
hood and reconnect the power.

Electrical connection

Electrical output: electrical cord + plug with
ground. To be plugged into socket with ground.
Check for compatibility with information on type
plate (behind filter).
Socket must be within reach.
Changes or replacement of the electrical cord
should be performed by a professional only.
Dimensions: p. 18
Electrical scheme: p. 19
EN 17