Replacing The Lamps; Electrical Connection - Novy 7600 Mode D'emploi Et D'installation

A self restoring thermocontact switches the motor
off in case of overheating. The motor is ready for
use when cooled off sufficiently.
Maintenance
Maintenance of the grease filter
The hood contains one or 2 metal filters (according
to the model) which should be cleaned twice a
month.
Grease filter indication
After 20 cooking hours, the 4 LEDs will start to
blink during 5 minutes, this indicates that the
grease filter has to be cleaned. When replacing
the cleaned filter, you have to reset the hood by
pushing the – button during 5 seconds . If you
don't reset, the LED lights will continu blinking.
Access to the filter
Take hold of the right and left side of the plate (a)
an pull down simultaneously. Remove the filter (b)
by taking hold of its hook and by pulling it down.
Cleaning the filter:
• in the dishwasher
• manually: in a hot solution of water and a
liquid detergent. Rince and allow to dry com-
pletely
Important! The previous instructions need to
be followed. If not an increased fire hazard may
occur.
Maintenance of the hood
Please allow the lights to cool down sufficiently
before cleaning the hood. Use a soft, wet cloth
and a mild detergent to clean the hood. Never
use aggressive, abrasive detergents or sponges.
Bleach will damage stainless steel.
The stainless steel surfaces can be treated with
Novy Inoxcleaner (906.060) after cleaning.

Replacing the lamps

Please allow the lights to cool down sufficiently
before touching them. Cover and protect delicate
surfaces underneath the hood when changing
lamps. The hood needs to be disconnected from
the current before proceeding.
Replacing the lamps
Attach the suction device to the lamp
Pull towards you
Put a new lamp in place using the same suction
device
The cookerhood has 4 lamps of the following
type 12V/20W/ ø35/GU4/°38
Total energy consumption with lightning:
7600: 250W
7610: 290W
7605-7615:
• With 245999: 330W
• With 445999: 270W

Electrical connection

Electrical output: electrical cord + plug with
ground. To be plugged into socket with ground.
Check for compatibility with information on type
plate (behind filter). Socket must be within reach.
Changes or replacement of the electrical cord
should be performed by a professional only.
Dimensions: p. 22
Electrical scheme: p. 23
EN 13