Replacing The Lamps; Electrical Connection - Novy 650 Mode D'emploi Et D'installation

Maintenance
Grease filter
After 30 cooking hours, the 4 LEDs will start
flashing when they are turned off. This indicates
that the grease filter needs cleaning.
Access to the grease filter
The grease filters can be taken out of the hood by
opening the drawer (1). The grease filter has been
placed behind this. The type 650 has 1 metal
grease filter and type 655 has 2 grease filters. You
can remove the filter by pulling the handle in the
filter (2).
Protect the cooking plate. You can take the grease
filter out of the hood by pulling the handle that
has been placed on the filter. The filter will come
down.
Cleaning the filter:
• in the dishwasher
• manually: in a hot solution of water and a
liquid detergent. Rince and allow to dry com-
pletely
Important! The previous instructions need to
be followed. If not an increased fire hazard may
occur.
Carbon filter (only with recirculation)
After 120 cooking hours, the LEDs remain lit for 30
seconds when they are turned off. This indicates
that the carbon filter needs cleaning (if present). It
is recommended to clean the fat filter at the same
time.
Access to the carbon filters
Remove the fat filters from the hood. The carbon
filters have been screwed at the left and the right
sides on the motor in the hood. Remove the
carbon filter from the motor with a turning and
pulling movement.
Reset the timer
In order to reset the timer, press the button for
position 4 of the motor and hold it for at least 3
seconds.
Maintenance of the hood
Please allow the lights to cool down sufficiently
before cleaning the hood.
Use a soft, wet cloth and a mild detergent to clean
the hood.
Never use aggressive, abrasive detergents or
sponges. Bleach will damage stainless steel.
The stainless steel surfaces can be treated with
Novy Inoxcleaner (906.060) after cleaning.

Replacing the lamps

First take the plug from the wall socket or switch
off the power group. Let the lamps cool down
sufficiently before replacing them.
A suction cup for removing the lamps has been
delivered with the hood. Place the suction cup
onto the halogen spot and draw it towards you.
The lamp will now come out. You can also install
the new lamp using the suction cup.

Electrical connection

Electrical output: electrical cord + plug with
ground. To be plugged into socket with ground.
Check for compatibility with information on type
plate (behind filter).
Socket must be within reach.
Changes or replacement of the electrical cord
should be performed by a professional only.
Dimensions: p. 16
Electrical scheme: p. 17
EN 15