Replacing The Lamps - Novy 7510/15 Mode D'emploi Et D'installation

Remove the Monoblock recirculation filter:
• Open the bottom plate with both hands and
remove the aluminium grease filter from the
hood.
• The Monoblock recirculation filter is found in
its opening in the cooker hood. Remove it from
the cooker hood.
Regenerate the Monoblock recirculation filter:
• The Monoblock can be regenerated up to 12
times. This is done in the oven.
• Place the filter in the oven for 1 hour at 120°C.
Provide sufficient fresh air in the room where
the oven has been placed, as smells can be
released. Smells can be released when baking
certain kinds of fish. The best solution for this is
to immediately regenerate the filter.
Reset the Monoblock recirculation filter
The cooker hood (motor) must be running!
Simultaneously press + and – for 5 sec. until the
red indicator lamp flashes 3 times for confirmation.
Place the Monoblock recirculation filter:
• Open the bottom plate with both hands and
remove the aluminium grease filter from the
hood.
• Place the Monoblock recirculation filter is its
opening in the cooker hood.
• Put back the aluminium grease filter and close
the bottom plate.
Deactivate the programming:
Attention! This is not recommended for a cooker
hood with recirculation.
Simultaneously press + and – for 5 sec. until the
third green LED flashes 3 times.
Maintenance of the bottom side of the cooker
hood
Please allow the lights to cool down sufficiently
before cleaning the hood. Use a soft, wet cloth
and a mild detergent to clean the hood.
Never use aggressive, abrasive detergents or
sponges. Bleach will damage stainless steel.
The stainless steel surfaces can be treated with
Novy Inoxcleaner (906.060) after cleaning.
Maintenance of the Solid Surface material
The housing is made from Solid Surface. Cleaning
is done using a cloth or sponge moistened with a
mild detergent. Then rub dry with a dry, soft cloth
to avoid stains. Do not use an abrasive or scourer.

Replacing the lamps

Please allow the lights to cool down sufficiently
before touching them. Cover and protect delicate
surfaces underneath the hood when changing
lamps. The hood needs to be disconnected from
the current before proceeding.
1. Carefully slide down the spotlight holder and
then open the spotlight holder with a tilting
movement.
2. Removing the LED lamp:
A. First disconnect the cable to the LED to be
replaced. Disconnect by means of releasing
the lock, by applying light pressure while at
the same time pulling away.
B. Next, remove the LED to be replaced by
making a gentle rotating movement to the left.
3. Mounting the new LED:
A. Place the new LED light into the locking ring.
B. Make a rotating movement to the right until
the LED light is locked.
C. Connect the power cable.
D. Put back the cover at its place.
EN 20