DeWalt DCN650 Guide D'utilisation page 14

English
Fig. J
15
Headlights (Fig. K)
There is a headlight located on each side of the nailer.
4
Headlights turn on upon battery insertion, activation of
the trigger, or depressing the contact trip. The lights will
automatically shut off after 20 seconds unless tool remains
in use.
nOTE: These headlights are for lighting the immediate work
surface and are not intended to be used as flashlights.
lOW BATTERY inDiCATOR: The left-side headlight will
flash four consecutive times and then shut down to indicate
low battery.
JAMMED nAil inDiCATOR: The right-side headlight will
flash continually if a nail becomes jammed in the nosepiece
(see Clearing a Jammed Nail).
Fig. K
4
Clearing a Jammed Nail (Fig. L)
If a nail becomes jammed in the nosepiece, keep the tool
pointed away from you and follow these instructions
to clear:
1. Remove battery pack from tool and engage the trigger
lock-off.
2. Pull the pusher back and remove any loaded nails.
3. Lift the jam clear latch
5
nosepiece door.
4. Remove bent nail, using pliers if necessary.
5. If driver blade is in the down position, cycle the stall
release lever 15 using enough force to fully slide it to
the other end of the slot in the housings.
6. Close the nosepiece door
under the two arms
17
latch until it locks in place.
12
3
then pull up to open the
18 and engage the latch pin
on the nosepiece. Push
19
7. Reinsert nails into magazine (see loading the Tool)
8. Reinsert battery pack.
nOTE: The tool will disable itself and not
reset until the battery pack has been removed
and reinserted.
nOTE: Should nails continue to jam frequently in nosepiece,
have tool serviced by an authorized D
Fig. L
5
18
19
Cold Weather Operation
When operating tools at temperatures below freezing:
1. Keep tool as warm as possible prior to use.
2. Actuate the tool 5 or 6 times into scrap lumber
before using.
Hot Weather Operation
Tool should operate normally. However, keep tool out of
direct sunlight as excessive heat can deteriorate bumpers
and other rubber parts resulting in increased maintenance.
MAINTENANCE

WARNING: To reduce the risk of serious personal
injury, turn unit off and remove the battery pack
before making any adjustments or removing/
installing attachments or accessories. An
accidental start-up can cause injury.
Cleaning

WARNING: Blow dirt and dust out of all air vents with
clean, dry air at least once a week. To minimize the risk
of eye injury, always wear ANSI Z87.1 approved eye
protection when performing this.

WARNING: Never use solvents or other harsh
chemicals for cleaning the non-metallic parts of
the tool. These chemicals may weaken the plastic
materials used in these parts. Use a cloth dampened
only with water and mild soap. Never let any liquid
get inside the tool; never immerse any part of the tool
into a liquid.
WALT service center.
e
17