Ryobi EMS254L-LSG Traduction Des Instructions Originales page 7

The dust produced when using the product may be
harmful to health. Use a dust suction system and wear
a suitable dust protection mask. Remove deposited
dust thoroughly with a vacuum cleaner.
Do not replace the laser or LED with a different type. Any
repairs must only be carried out by the manufacturer or
authorised service agent.
The unit should be connected to a power circuit
protection device (fuse or circuit breaker).
When using the mitre saw outdoors, the manufacturer
recommends the use of an RCD device with a trip set
at 30mA.
When using this tool, voltage fluctuations may affect
other electrical products or lighting on the same
power circuit. Connect the tool to a power source with
fluctuations. Contact your electric power supplier for
further clarification.
LASER SAFETY RULES
The laser radiation used in this saw is Class 2 with
into the laser beam. Failure to comply with the rules
could result in serious personal injury.
Do not stare into beam during operation.
Do not project the laser beam directly into the eyes of
others. Serious eye injury could result.
Do not place the laser in a position that may cause
anyone to stare into the laser beam intentionally or
unintentionally.
Do not use optical tools to view the laser beam.
Do not operate the laser around children or allow
children to operate the laser.
Do not attempt to repair the laser device by yourself.
Do not attempt to change any parts of the laser device
by yourself.
Any repairs must only be carried out by the laser
manufacturer or authorised service agent.
Do not replace the laser with a different type.
RESIDUAL RISKS
Even when the product is used as prescribed, it is still
impossible to completely eliminate certain residual risk
factors. The following hazards may arise and the operator
should pay special attention to avoid the following:
Risk of contact with uncovered parts of the rotating saw
blade
Kick-back of workpieces or parts of workpieces due to
improper adjustment or handling
Catapulting of faulty carbide tips from the saw blade
Damage to the respiratory system
NOTE: Wear respiratory protection masks containing
filters appropriate to the materials being worked.
Ensure adequate workplace ventilation. Do not eat,
drink or smoke in the work area.
Damage to hearing if effective hearing protection is not
worn.
WARNING
Dust from certain paints, coatings and materials may
cause irritation or allergic reactions to the respiratory
system. Dust from wood such as oak, beech, MDF and
others are carcinogenic. Material containing asbestos
specialist operators.
WARNING
Injuries may be caused, or aggravated, by prolonged
use of a tool. When using any tool for prolonged periods,
ensure you take regular breaks.
KNOW YOUR PRODUCT
See page 226 - 227.
1. Handle, insulated gripping surface
2. Power switch
3. Safety lock handle
4. Upper guard
5. Saw blade
6. Lower guard
7. Main fence
8. Clamp
9. Turntable
10. Base
11. Table insert
12. Turntable lock handle
13. Balancing foot
14. Rubber foot
15. Laser switch
16. LED switch
17. Top handle
18. Lower guard cover
19. Bevel angle lock knob
20. Sliding fence
21. Mounting hole
22.
23. Stand
24. Screws for adjusting the bevel angle limit stop
25. Spindle lock knob
26. Dust bag
27. Cutting depth adjustment knob
28. Bracket stop
29.
30. Linear rod stop knob
31. Winding support
32. Screws for adjusting mitre angle
EN
English
FR
DE
ES
IT
NL
PT
DA
SV
FI
NO
RU
PL
CS
HU
RO
LV
LT
ET
HR
SL
SK
BG
UK
TR
EL
5