Hitachi G 13SP Instructions De Sécurité Et Mode D'emploi page 13

CAUTION:
Using this grinder with a carbon brush which is
worn in excess of the wear limit will damage the
motor.
NOTE:
Use HITACHI carbon brush No. 76 or No. 88
indicated in Fig. 6.
5. Carbon brush replacement
<Disassembly>
(1) Loosen the D4 tapping screw fastening the brush
cover and remove the brush cover from the handle
(Fig. 7-A).
Brush cover
Fig. 7-A
(2) Use a small screwdriver or similar tool, to shift the
end of the spring holding the carbon brush toward
the outside of the brush holder (Fig. 7-B).
Carbon
brush plug
Brush holder
Spring end
(3) Remove the carbon brush from the brush holder,
grasp the pigtail and disconnect the carbon brush
plug by pulling out. (Fig. 7-B).
Handle
D4 Tapping
screw
Pigtail
Fig. 7-B
<Assembly>
(1) Use a small screwdriver, etc., to insert the carbon
brush plug into the brush holder terminal (Fig. 7-
C).
Carbon brush plug
Brush holder terminal
(2) Insert the carbon brush into the brush holder, use
a small screwdriver or similar tool, to shift the end
of the spring onto the top of the carbon brush
(Fig. 7-D).
Carbon brush
Brush holder
Fig. 7-D
NOTE:
Make sure the end of the spring is not holding the
pigtail (Fig. 7-E).
Pigtail
Spring end
English
Fig. 7-C
Spring end
Fig. 7-E
13