Step 3: Unpacking, Moving, Placing And Anchoring The Cooktop - Thermador Professional PCG24 Manuel D'installation

3" Min.
3-Prong grounding type receptacle
connected to a properly grounded and
polarized electrical supply rated at 120VAC,
10 Amps, (or 15A*) Single Phase, 60 HZ.
NOTE: This is not applicable to 240 VAC
models with 24" electric griddle.**
All Installer supplied parts must conform to Local Codes.
*15 Amp 120 VAC electrical supply is required for 36" and 48" models with a 24" electric griddle.
**30 Amp 240 VAC electrical supply is required for models with a 24" electric griddle.
Step 3: Unpacking, Moving, Placing and
Anchoring the Cooktop
CAUTION
Proper equipment and adequate manpower
must be used in moving the appliance to avoid
damage and/or personal injury. The unit is
heavy and should be handled accordingly.
Important
• Verify that the appliance is correct for the type of gas
being provided. Refer to Step 4 before proceeding with
the installation.
• Attach the backguard before sliding the appliance into
the final installed position. See Step 6.
1. Remove the outer carton and packing material from the
shipping base. Ensure that you have all cooktop
components before proceeding.
English 10
Product Rating
Label/Serial Tag
Threading compounds must be
resistant to Propane Gas
Power
Cord or
Conduit
P24WOK 1/2" NPT
3/4" flex line
A manual valve must be installed
external to the appliance, in an acces-
sible location from the front, for the
purpose of shutting off the gas supply.
2. Remove the top grate castings, burner caps and grill
grate (if so equipped) to reduce unit weight.
NOTE:
Leave adhesive-backed foam layer over brushed-metal
surfaces, to protect finish from scratches, until the cooktop
is installed in its final position.
3. Lift and place the cooktop in the opening. Be careful
not to pinch the power cord or gas inlet. Care should be
used not to scratch the griddle cooking plate.
4. Make sure that the power cord is free and hanging
loose.
5. The cooktop must be level for proper performance.
6. The grill frame (if so equipped) has been leveled during
assembly so do not attempt to level the grill.
7. Replace the cooking grates, burner caps and grill plate
(if so equipped). Ensure that the burner caps are
correctly seated on the burner bases.
gas flow
Figure 9: Front - Bottom of Unit