Installation - Sony MEX-GS620BT Mode D'emploi

Notes on installing the connection cable RC-SR1 (not
supplied)
 Refer to the support sites on the back cover for
details, then connect each lead properly to the
appropriate leads. Making an improper connection
may damage the unit.
 Depending on the type of car, be sure to insulate the
unused leads with electrical tape for safety.
 Do not connect this cable when the steering wheel
remote control is not used.
 Consulting the dealer or an experienced technician
for help is recommended.
When using the wired remote control
1
To enable the wired remote control, set [STR
CONTROL] in [SET STEERING] to [PRESET] (page 19).

Installation

Removing the protection collar and the
bracket
Before installing the unit, remove the protection
collar  and the bracket  from the unit.
1
Pinch both edges of the protection collar
, then pull it out.

2
Insert both release keys  until they
click, and pull down the bracket , then
pull up the unit to separate.


Face the hook inwards.
Mounting the unit in the dashboard
 Before installing, make sure the catches on both
sides of the bracket  are bent inwards
2 mm ( 3 / in).
32
 For Japanese cars, see "Mounting the unit in a
Japanese car" (page 36).
1
Position the bracket  inside the
dashboard, then bend the claws outward
for a tight fit.

2
Mount the unit onto the bracket , then
attach the protection collar .

Notes
 If the catches are straight or bent outwards, the unit
will not be installed securely and may spring out.
 Make sure the 4 catches on the protection collar 
are properly engaged in the slots of the unit.
182 mm (7 1 /
53 mm (2 1 / in)
8
Catch

in)
4
35
GB