geo-FENNEL FL 300HV-G EasyGRADE Mode D'emploi page 27

Les langues disponibles

TILT FUNCTION (3)

After POWER ON the laser automatically activates the TILT function. The TILT LED (4) is flashing

during the activation procedure. When it is completed (after 90 sec. approx.) the LED is illuminated.

If the laser is disturbed rotation stops and the laser beam and TILT LED (4) will flash. The laser will

not re-level automatically.

To quit the TILT function press button (3).

If the laser is disturbed (i. e. due to a positional change of the tripod) it will automatically self-level

(within the self-levelling range of 5°); a height offset can occur. This will be avoided by using the TILT

function. The use of this function ensures that the laser is shut off even within the self-levelling range

if the laser is disturbed. Power on the unit and wait until the self-levelling procedure is completed.

VIBRATION-WIND-SECURITY FUNCTION (V-W-S) (5)

Press button (5) to activate the V-W-S function. The V-W-S LED (6) is illuminted and the TILT LED (4)

starts flashing. When the V-W-S LED (6) and the TILT LED (4) are both illuminated the V-W-S function

is activated. The V-W-S function automatically activates the TILT function. This function allows conti-

nuous operation during periods of vibration and wind. If a significant movement occurs the laser stops

rotating and the TILT LED (4) and the laser beam start flashing. Press the V-W-S button (5) to quit.

Press the V-W-S button (5) once again for re-activation.

OPERATION WITH THE REMOTE CONTROL