Titan RentSpray Plus Notice D'utilisation page 13

Table des Matières

Publicité

Les langues disponibles

Les langues disponibles

Problem
Excessive surge at the spray
gun.
Poor spray pattern.
The unit lacks power.
These products are covered by one or more of the following U.S. patents:
4,500,119
4,768,929
Material Safety Data Sheets (MSDS) are available on Titan's website or by calling Customer Service.
© Titan Tool Inc. All rights reserved.
Troubleshooting
Cause
1. Wrong type of airless spray hose.
2. The spray tip worn or too large.
3. Excessive pressure.
1. The spray tip is too large for the
material being used.
2. Incorrect pressure setting.
3. Insufficient fluid delivery.
4. The material being sprayed is too
viscous.
1. The pressure adjustment is too low.
2. Improper voltage supply.
Patents
Solution
1. Replace hose with a minimum of 50' of 1/4"
grounded textile braid airless paint spray
hose.
2. Replace the spray tip following the
instructions that came with the spray gun.
3. Rotate the pressure control knob
counterclockwise to decrease spray
pressure.
1. Replace the spray tip with a new or smaller
spray tip following the instructions that
came with the spray gun.
2. Rotate the pressure control knob to adjust
the pressure for a proper spray pattern.
3. Clean all screens and filters.
4. Add solvent to the material according to the
manufacturer's recommendations.
1. Rotate the pressure control knob clockwise
to increase the pressure setting.
2. Reconnect the input voltage for 120V AC.
13
English

Publicité

Table des Matières
loading

Table des Matières