Preparation - Beko FSE1073 Mode D'emploi

4

Preparation

• Your cooler/freezer should be
installed at least 30 cm away from
heat sources such as hobs, ovens,
central heater and stoves and at
least 5 cm away from electrical
ovens and should not be located
under direct sunlight.
• The ambient temperature of the
room where you install your cooler/
freezer should at least be 10°C.
Operating your cooler/freezer
under cooler conditions is not
recommended with regard to its
efficiency.
• Please make sure that the interior
of your cooler/freezer is cleaned
thoroughly.
• If two cooler/freezers are to be
installed side by side, there should
be at least 2 cm distance between
them.
• When you operate your cooler/
freezer for the first time, please
observe the following instructions
during the initial six hours.
• The door should not be opened
frequently.
• It must be operated empty without
any food in it.
• Do not unplug your cooler/freezer.
If a power failure occurs out of your
control, please see the warnings in
the "Recommended solutions for
the problems" section.
• Original packaging and foam
materials should be kept for future
transportations or moving.
• Due to temperature change as
a result of opening/closing the
product door during operation,
condensation on the door/body
shelves and the glass containers is
normal.
• It is important the appliance freezes
the warmest test package below -18
C at the RECOMMENDED thermostat
setting. The test is carried out with
the baskets/drawers in place as if
used by the consumer at normal
conditions. Fast freezing function is
not engaged. Ambient temperature
is 25 C. Storage temperature
performance accounts 20-30% of
overall rating.
15
EN