Table des Matières
Publicité
47
7
PRE-OPERATIONAL CHECKS (DAILY CHECKS)
In order to prevent occurrence of troubles and accidents, the operator must know the condition of the machine at all times.
The pre-operational checks must be daily performed before start of the work.
1. Defect found on the day before.
2. Check around the machine for oil, water leakage.
3. Check for loose bolts, nuts missing of pins.
4.Check coolant level in reserve tank, and replenish.
5. Check fuel level.
6. Check engine oil, and replenish.
7. Check HST oil, and replenish.
8. Apply grease or oil to each part.
9. Check and adjust belt tension.
10. Check crawler tension.
11. Check battery liquid level.
12. Check radiator and oil cooler.
13. Check brake pedal stroke.
14. Check drive pedal operation.
15. Check alarm lamps and horn.
16. Check for burning-out, shorting, loose terminals of electric wiring.
17. Clean the wiring and engine.
18. Check labels.
19. Check seat belt and ROPS.
Items
Engine
Radiator
Fuel piping
Transmission
Hydraulic pump
Hydraulic cylinder
Hydraulic hose joint
HST pump
HST tank
Roller / Idler
Frame set bolts
Others
1. Fan belt
2. HST unit drive belt
3. Hydraulic pump drive belt
Remarks & Ref. pages
––––––––––
If impossible, ask the
specified service plant.
Tighter up
Page 67
Page 57
Page 63
Page 77
Page 89
Page 101
Page 95
Page 101
Page 103
Page 85
Page 67
Page 95
Page 99
––––––––––
––––––––––
––––––––––
––––––––––
––––––––––
Publicité
Table des Matières
